A su vez, permite saber la temperatura de dicho elemento. Hay muchas formas de lograr este resultado. Para medir correctamente el volumen se agrega agua destilada. Normalmente debe medirse el volumen del agua sola y luego se mide el volumen de la sustancia que se desea analizar junto con el agua destilada.
|Published (Last):||25 May 2010|
|PDF File Size:||9.62 Mb|
|ePub File Size:||15.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
Gas Displacement Pycnometry System Gas pycnometry is recognized as one of the most reliable techniques for obtaining true, absolute, skeletal, and apparent volume and density.
This technique is non-destructive as it uses the gas displacement method to measure volume. Inert gases, such as helium or nitrogen, are used as the displacement medium. Density calculations using the gas displacement method are much more accurate and reproducible than the traditional Archimedes water displacement method.
The AccuPyc II Series Pycnometers are fast, fully automatic pycnometers that provide high-speed, high-precision volume measurements and true density calculations on a wide variety of powders, solids, and slurries. After analyses are started with a few keystrokes, data are collected, calculations are performed, and results displayed. A minimal amount of operator attention is required. Maintain product integrity with this non-destructive test Eliminate error with programmable automatic repeat and data acquisition set to your tolerances to comply with your SOPs Ability to use a variety of gases Maximize your investment-Adaptive configuration to meet your sample size needs Low-cost, minimal maintenance, and small footprint Increase efficiency and compliance with barcoding compatibility Speed of analysis, accuracy, repeatability, and reproducibility Versatility of keypad or Windows software operation Eliminate procedural steps with direct input from an analytical balance This technique uses the gas displacement method to measure volume accurately.
The sample is sealed in the instrument compartment of known volume,the appropriate inert gas is admitted, and then expanded into another precision internal volume. The pressures observed upon filling the sample chamber and then discharging it into a second empty chamber allow computation of the sample solid phase volume. Helium molecules rapidly fill pores as small as one angstrom in diameter; only the solid phase of the sample displaces the gas.
Dividing this volume into the sample weight gives the gas displacement density. Total Density On an elementary level, the volume of a solid material can be calculated by measuring its length, width, and thickness. However, many materials have within their structure surface irregularities, small fractures, fissures, and pores.
Some of these voids or pores are open to the surface or closed within the structure of the solid material. Therefore, differences in the material volume depend on the measurement technique, measurement method, and the conditions under which the measurements were performed. Density Type.
Determinazione della densità