ASTM E2112 - 07 PDF

More E Scope 1. For the purpose of this practice, fenestration products shall be limited to windows, sliding patio-type doors, swinging patio type doors, and skylights, as used primarily in residential and light commercial buildings. This practice attempts to educate the installer, builder, architect, and other users in the identification and understanding of the water shedding system of the building envelope. It does not cover the fabrication or assembly of multiple units, whether such fabrication takes place in a factory or at the intended installation site.

Author:Samulkree Tur
Country:Zimbabwe
Language:English (Spanish)
Genre:Automotive
Published (Last):6 September 2017
Pages:45
PDF File Size:6.71 Mb
ePub File Size:18.57 Mb
ISBN:515-8-75379-145-4
Downloads:85973
Price:Free* [*Free Regsitration Required]
Uploader:Gutaxe



More E The general contractor shall be responsible for the necessary coordination of trades and proper construction sequencing of the installed fenestration product. It may promote the deterioration of wall constructions, insulation, fenestration products, and their respective finishes. It further assumes familiarity with flashing and sealing, glazing procedures, finishes where applicable, and an understanding of the fundamentals of construction that affect the installation of these units.

Scope 1. For the purpose of this practice, fenestration products shall be limited to windows, sliding patio-type doors, swinging patio type doors, and skylights, as used primarily in residential and light commercial buildings.

This practice attempts to educate the installer, builder, architect, and other users in the identification and understanding of the water shedding system of the building envelope. It does not cover the fabrication or assembly of multiple units, whether such fabrication takes place in a factory or at the intended installation site.

The installer should check with the manufacturer of factory-assembled units for instructions for anchoring. This practice does not cover the selection of appropriate fenestration products for a given application, nor the selection of other products or systems for use in the installation. Actual conditions in buildings vary greatly and, in some cases, substantial additional precautions may be required.

This practice is not intended to limit or exclude other new procedures that may refine or further improve the effectiveness of fenestration installation. Further, this practice attempts to consolidate and unify the various steps of construction, tying together the various trades involved with the continuity between fenestration products and the building envelope. These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this practice.

Furthermore, this practice does not purport to provide fail-safe installation methods, assurance or protection against installation deficiencies, or a standard by which architects can specify or ensure delivered performance.

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 5, Related Procedures. Where an asbestos hazard is known or suspected, refer to the ASTM Manual on Asbestos Control, and to applicable state and federal regulations.

CAUTIVA Y SEDUCIDA LEES HALEY DESCARGAR PDF

ASTM E2112-07: Standard Practice for Installation of Exterior Windows, Doors and Skylights

.

COP8CBR9 DATASHEET PDF

.

ALLEMAAL ANDERSDENKENDEN PDF

.

Related Articles