Wide common-mode Rejection ratio of 70dB to 86dB and wide voltage supply range A low input bias current less Power Requirement Supply current is 1. The TLIC can be used in all those applications requiring a high slew rate, low input bias current and offset voltage and wide bandwidth. As it is an op-amp IC, therefore, it is used in voltage followers, ac to dc conversions, sample and hold circuits, high-speed integrators. It is used for performing mathematical calculations. In addition to all these circuits, our computers, tablets and personal electronics also use this IC. Pin 2 is the inverting terminal of the amplifier and pin 3 is the non-inverting terminal.
|Published (Last):||11 December 2019|
|PDF File Size:||15.99 Mb|
|ePub File Size:||4.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
Buyers should obtain the latest relevant information before placing orders and should verify that such information is current and complete.
Testing and other quality control techniques are used to the extent TI deems necessary to support this warranty. Except where mandated by applicable law, testing of all parameters of each component is not necessarily performed. Buyers are responsible for their products and applications using TI components.
TI does not warrant or represent that any license, either express or implied, is granted under any patent right, copyright, mask work right, or other intellectual property right relating to any combination, machine, or process in which TI components or services are used. Information published by TI regarding third-party products or services does not constitute a license to use such products or services or a warranty or endorsement thereof.
Use of such information may require a license from a third party under the patents or other intellectual property of the third party, or a license from TI under the patents or other intellectual property of TI. Reproduction of significant portions of TI information in TI data books or data sheets is permissible only if reproduction is without alteration and is accompanied by all associated warranties, conditions, limitations, and notices.
TI is not responsible or liable for such altered documentation. Information of third parties may be subject to additional restrictions. Resale of TI components or services with statements different from or beyond the parameters stated by TI for that component or service voids all express and any implied warranties for the associated TI component or service and is an unfair and deceptive business practice.
TI is not responsible or liable for any such statements. Buyer acknowledges and agrees that it is solely responsible for compliance with all legal, regulatory and safety-related requirements concerning its products, and any use of TI components in its applications, notwithstanding any applications-related information or support that may be provided by TI. Buyer represents and agrees that it has all the necessary expertise to create and implement safeguards which anticipate dangerous consequences of failures, monitor failures and their consequences, lessen the likelihood of failures that might cause harm and take appropriate remedial actions.
Buyer will fully indemnify TI and its representatives against any damages arising out of the use of any TI components in safety-critical applications. In some cases, TI components may be promoted specifically to facilitate safety-related applications.
Nonetheless, such components are subject to these terms. No TI components are authorized for use in FDA Class III or similar life-critical medical equipment unless authorized officers of the parties have executed a special agreement specifically governing such use.
TLO81 Datasheet PDF - Texas Instruments
TL081/ TL082/TL084 JFET-Input Operational Amplifiers